So Tyler,

I guess you know water can be a lot of trouble for touch screens. The most vulnerable is SAW which stops dead in its tracks, to the least vulnerable, resistive touch. Resistive can be sealed so that water does not get in between the PET and glass layers which allows for better performance with water.

The ultimate irony is that most touch screens work because humans are just big bags of salt water and the water in our bodies serve as the primary activating mechanism. The problem is that the touch screen must distinguish between you, the big salt water bag, and the salt water puddle. (There is one rare form of an acoustic touch system than operates in a fully submersible ocean environment, but Touch Guy will ignore that one for now because it is made by a competitor).

So Touch Guy, still the SUPER-CHAMPION of projected capacitive needs to come clean on water and multi-touch. And if you follow Touch Guy, you know his answer to most questions is, “it depends.” In this case, it depends a whole lot on which sensing IC (Integrated Circuit/Chip) you use. Most ICs will invariably yell, “I quit!”, when it gets a lot of water on it – check out your iPhone sometime. The best IC could be saying, “I love water!”, and works really well. The water-loving IC will even work covered in distilled water, but as the salinity increases (as would be the case on the ocean) a salt spray is as far as you can take it. So your projected capacitive fish finder will work on the local lake in a light rain, but bow-busting 40 foot ocean waves are probably a little much.

Still need to survive the salt water wave and keep on multi-touching? Then the Resistive MARS technology is the one for you. Silicone-sealed behind a water tight bezel, this touch screen can take that salt water puddle and keep on touching. Add sunlight readable filters to the MARS sensor and you are ready for a jaunt around the continent on the bridge of your new yacht!

Until next time,
Touch Guy